Motor Speed Control with One Transistor

Project tutorial by Marcazzan_M

  • 254 views
  • 2 comments
  • 7 respects

Sensitive Jack-o'-Lantern

Project tutorial by Marcazzan_M

  • 49 views
  • 0 comments
  • 5 respects

LED Cube 7x7x7

Project tutorial by Marcazzan_M

  • 5,837 views
  • 10 comments
  • 32 respects

Toolbox 3


Replicated projects 0

 Marcazzan_M hasn't replicated any projects yet.

Petoi Nybble

Project showcase by Rongzhong Li (李荣仲)

  • 22,458 views
  • 38 comments
  • 326 respects

Dark Theme for Arduino IDE

Project tutorial by the lonely programmer

  • 8,802 views
  • 11 comments
  • 67 respects

Easy Countdown with Buzzer

Project showcase by Marcazzan_M

  • 11,061 views
  • 3 comments
  • 14 respects

  • LED Cube 7x7x7 25 days ago

    Ok, you can calculate the necessary resistance in this way:
    (average voltage)/current
    In this case for a current around 10mA you need: (5V-3.25)V/10mA=175 ohm, You should use a resistor around this value.
    Obviously 5V is the supply voltage.

  • LED Cube 7x7x7 25 days ago

    Hi you can use 220 ohm resistors so you will have a current around 13mA, I think it is enough. If you want you can use also 330 ohm resistors so you will have a current around 8mA.
    You can choose one of it considering the best quantity of light for you.

  • LED Cube 7x7x7 4 months ago

    Hi, you can solve this problem with the technique of multiplexer, you can divide the image in some frames each frame is easier than the entire image and the combination of all frames create the image. In this way you can use less LEDs at the same time and the IC can provide the necessary current.

Add projectSign up / Login