Public projects 2

Air surfer

by Anton

  • 117 views
  • 0 comments
  • 0 respects

Air Surfer

Project tutorial by Anton

  • 30,552 views
  • 27 comments
  • 157 respects


Replicated projects 0

 Anton hasn't replicated any projects yet.

Respected projects 3

Beautifully Finished Humidity and Temperature Sensor

Project tutorial by Wicked Makers

  • 17,926 views
  • 21 comments
  • 138 respects

DIY Pet Feeder Using Bolt

Project showcase by Shoeb Ahmed

  • 4,144 views
  • 0 comments
  • 27 respects

Good Sleep - Your Sleep Assistant

Project tutorial by Jey Biddulph

  • 2,087 views
  • 2 comments
  • 21 respects

  • Air Surfer 12 months ago

    Dimensions are 12.5x13x5cm, holes for buttons depend on the buttons type. Mine was 12mm in diameter. Then 5mm diameter holes for LEDs and a photo resistor. The screen it tricky because it depends on the type of the screen.

  • Air Surfer 12 months ago

    The 1st is for hours adjusting, 2nd for minutes and the 3rd one is for font color changing)
    Right now there are more functions such as 1st and 2nd pressed CO2 sensor switches off auto calibration. If 1st and 3rd one are pressed it will perform zero calibration for CO2 sensor.

  • Air Surfer 12 months ago

    Hi Jimmy, I just soldered wires to the back side of the arduino.

Add projectSign up / Login