Project showcase
Getting Started with Arduino/Genuino 101

Getting Started with Arduino/Genuino 101 © Apache-2.0

This post will demonstrate how to configure Arduino/Genuino 101 for the first time and blink a LED.

  • 3,345 views
  • 2 comments
  • 13 respects

Components and supplies

Apps and online services

About this project

Introduction

This guide will demonstrate to beginners how to getting started with Arduino/Genuino 101 for the first time. This post will demonstrate the installation of Arduino/Genuino 101 board in Arduino IDE and then show the Blink LED example.

Below is the picture of things that we need to get started with Genuino/Arduino 101.

Now plug the jumper wire ground pin to LED cathode point and digital pin 7 to anode of LED.

Getting the Arduino IDE

If you have the Arduino IDE then it's OK, else download the Arduino IDE from here. Now open the Arduino IDE. Go to Tools->Board:->Board Manger:

Click on Board Manager.

Type "Genuino 101 " or "Arduino 101" or you can just type "101" and you will get the package for Arduino/Genuino 101 board. Click on install button.

Now Arduino IDE is ready to support Arduino/Genuino 101 board. Navigate to File->Examples->01. Basics->Blink

Change the Pin from 13 to 7 in a Code.

Review this Video it contains all the steps including output.

Code

Blink Led CodeArduino
// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin 13 as an output.
  pinMode(7, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(7, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);              // wait for a second
  digitalWrite(7, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);              // wait for a second
}

Comments

Similar projects you might like

Arduino 101 BLE App

Project in progress by Alexis Santiago Allende

  • 10,794 views
  • 26 comments
  • 51 respects

Oled Display with Arduino 101

Project tutorial by Alexis Santiago Allende

  • 6,083 views
  • 1 comment
  • 25 respects

Control LED/Relay Using Arduino 101

Project tutorial by Shivansh Singh

  • 2,808 views
  • 1 comment
  • 5 respects

Accelerometer Using Arduino 101

by Jefferson Paredes

  • 2,663 views
  • 0 comments
  • 3 respects

Arduino 101 Home BLE System

Project tutorial by Alexis Santiago Allende

  • 2,596 views
  • 0 comments
  • 12 respects
Add projectSign up / Login