IoT with ESP8266

Project tutorial by moty

  • 1,107 views
  • 0 comments
  • 9 respects

IoT with ENC28J60

Project tutorial by moty

  • 1,308 views
  • 0 comments
  • 7 respects

ENC28J60 on the Web

Project tutorial by moty

  • 960 views
  • 0 comments
  • 8 respects

Toolbox 1


Replicated projects 0

 moty hasn't replicated any projects yet.

Tanker - A IoT Aquarium

Project showcase by vapor83

  • 1,131 views
  • 0 comments
  • 2 respects

DIY Relay Outlet Arduino

Project tutorial by Ben Jones

  • 24,392 views
  • 17 comments
  • 32 respects

Arduino DIY Analog Thermometer

Project tutorial by Nick Koumaris

  • 1,331 views
  • 1 comment
  • 3 respects

  • Counter 4 months ago

    The reason for the error is the code in line 58. Every 32768 counts of the input the line of code is executed and stops the count for the duration. A good solution would have been for the counter to reset itself but the hardware doesn't have this option.
    I wanted the math in the code to look sensible so I left this error. You can change the number in line 54 (OCR1A = 32767;) to 32755 or another near number to correct the displayed frequency readings. Check the readings of several input frequencies to make sure it works for you.

  • Water Softener 5 months ago

    Add the diode, LED and resistor across any of the 10 ohm resistor, as the circuit above.

  • Water Softener 5 months ago

    You are welcome. If already a section of your pipe is made of plastic wind the coil there, otherwise wind it on copper pipe.

Add projectSign up / Login