The CHPC is a minimal cost heat pump (HP) controller.
Project tutorial by gonzho
Automated Home using Raspberry Pi 2 (Windows 10 IoT Core) and Arduino.
Project tutorial by Anurag S. Vasanwala
How to control several roller shutters with inexpensive relay boards (not ruining them) with physical buttons and remotely simultaneously.
Project tutorial by gomecin
Controlling a car using a Pebble watch, an Android phone and an Arduino
Project tutorial by Mika Wee
Use the IO Expander and Relay Expander with the Arduino to control up to 65,280 relays!
Project tutorial by Christian
Use your Smartphone to turn power on/off.
Project in progress by Sameer
PIR sensors allow you to sense motion, almost always used to detect whether a human has moved in or out of the sensors range. They are small
Project tutorial by DIY Partners
Arduino powered thermostat and fan controller with overheating alarm.
Project tutorial by BuddyC
Use your android smartphone to open and close your garage door reliably (Under Development)
Project in progress by David Smerkous
How to make LAN/Ethernet relay switch using Arduino UNO and ethernet shield ENC28j60.
Automatically switches on/off a battery charger.
Project showcase by John Wood
I played smartphone games with a relay touch board.
Project showcase by HomeMadeGarbage
Commercial Automation for a lumber mill including relay controls and sensor networks to run daily operations.
Project in progress by amosp33
Use a Electret Mic to turn a light on and off.
Project tutorial by Mark Tashiro
An WIZnet powered Arduino Server used for Home automation. The receiving end would be node MCU devices.
Project tutorial by Dhairya Parikh
Control your home appliances connected to a smart socket extension box with your voice using Alexa.
Project tutorial by Emmanuel Edwards
Arduino with Cayenne enables you to control and monitor your electric devices from anywhere in the world.
Project showcase by PauliusPlus
Lamp controlled by magic hands.
by Nekhil ravi and TechRider
Looking to make a relay board yourself? Then you're in the right place.
Project tutorial by suhail jr
When the vibration module detects vibration, the lamp will go on for 2 seconds and this for 3 times.
Project tutorial by MichDragstar
Intel Edison expands a new 3-D printer market.
Project tutorial by 4 developers
Or connect with your social account:
New here? Create an account