Sound Warning

Components and supplies

Arduino UNO & Genuino UNO

Adafruit Microphone Amplifier Breakout

Buzzer

Amazon Alexa Cirrus Logic Voice Capture Development Kit

LED SWITCH 3 PRONG

Necessary tools and machines

Hot glue gun (generic)

Apps and online services

Arduino IDE

About this project

Sound Warning

This is Warning device When the sound exceeds the set level. The KY-037 is a voice receiver. And exported with ISD-1820 and BUZZER. The ISD-1820 is a voice recorder and plays if configured to match KY-037 and Set KY-037 to analog because analogue is a measurement that can measure the sound, which is different from the digital values can be measured only 0 and 1.

Steps

Step 1

Let's check the sound value. If the sound turns on, the LED will turn on.

Step 2

Add the buzzer and check the sound value together. If the sound turns on

Step 3

Add the sound recorder with check the sound value. If the sound turns on,the buzzer and recorder will turn on.

Step 4

Type code.

Step 5

Add the LED SWITCH 3 PRONG

Step 6

Complete arranging the components.

Code

Sound warningC/C++

int sensorPin = A0;    
int sensorValue = 0;     
int song = 2;         
int SOUT = 11;
int PLAYE = 9;

void setup()
{
  pinMode (sensorValue,INPUT);    
  pinMode (song,OUTPUT);          
  pinMode (SOUT, INPUT);
  Serial.begin(9600);
}

void loop()
{
  sensorValue = analogRead(sensorPin);    
  Serial.println(sensorValue);
  delay(1000);    
  int ret = digitalRead(SOUT);

if (sensorValue > 500)   
  {
    tone(song,500,300);
    Serial.println("--------------> PIR");
    digitalWrite(PLAYE, 1);
    delay(5000);
    digitalWrite(PLAYE, 0);
    noTone(song);             
    delay(3000);
  }
}