Components and supplies
Through Hole Resistor, 470 ohm
Capacitor 1000 µF
White + Glossy Spray paint
Arduino Nano R3
Wood Glue
Hook Up Wire Kit, 22 AWG
SparkFun Solder-able Breadboard
DC POWER JACK 2.1MM BARREL-TYPE PCB MOUNT
Card Board
3/8" plywood (~21 x 31" for main piece, then some extra for frame)
USB to 2.1mm DC jack cord
Misc. Hardware
Paint Stuff
Tools and machines
X-Acto Knife
Hot glue gun (generic)
Soldering iron (generic)
Circular/ Hand Saw
Dremel + sawblade bit
Apps and platforms
Arduino IDE
FastLED Library
Project description
Code
Northern Lights Routine
arduino
This is the code for the Light routine. Pay attention to if you used the same pins. DO NOT HAVE THE NANO AND THE 5V POWER CONNECTED AT THE SAME TIME, YOU WILL FRY IT. When powering the Nano through the 5V pin, you are by-passing the voltage regulator. If you want to avoid this or don't trust your power supply to be consistent, look up how to power an arduino and peripherals separately.
Downloadable files
Circuit/ Wiring
Circuit/ Wiring
Circuit/ Wiring
Circuit/ Wiring
Comments
Only logged in users can leave comments
sholtsnolts
0 Followers
•0 Projects
Table of contents
Intro
6
0