This is an Arduino Uno with a DHT11 temp/humidity sensor with and LCD screen powered by a power bank.
Project tutorial by ThothLoki
In this tutorial, we will learn how to detect Smoke and inflammable gases using an MQ-2 sensor.
by Aritro Mukherjee
In this protip, I will show you how to build DS18B20 Digital Thermometer with Arduino.
by Konstantin Dimitrov
This is tutorial to help you understand ultrasonic and buzzer and go deeper into learning Arduino, follow these steps and give me feedback.
Project tutorial by Ammar Atef Ali
Use the DHT Temperature Sensors in C# code via a C++ Windows Runtime Component to implement a one-wire protocol on Windows 10 and the RPI2.
Project tutorial by Daniel Porrey
Simple Temperature Monitoring with DHT22 & Arduino.
by Muhammad Afzal
Did you know that a standard three-wire PC Fan can be used as a sensor?
by Daniel Porrey
The sunflower follows the light using a servo motor and two photoresistors.
Project tutorial by Rick_Findus
It is a simple tutorial on how to create little a security device using an Arduino.
Project tutorial by Ivan
Short and easy, read distance 2 - 400 cm and plot it in I2C OLED screen.
Project tutorial by javier muñoz sáez
I'm going to show you how to make an LCD thermometer with an Arduino UNO and a LM35/36 analog temperature sensor.
Project tutorial by Konstantin Dimitrov
Very useful project made at school that detects some weather data.
Project tutorial by GilettaStefano
A project that displays the temperature and humidity of a room on your mobile in real time.
Project showcase by Kaustubh Agarwal
Check the humidity & temperature of your terrarium with a DTH22 humidity and temperature sensor and display this on an LCD I2C 16x2 display.
Project tutorial by Team GiftedMedia
A step-by-step tutorial for interfacing an IMU (Inertial Measurement Unit) sensor with an Arduino and reading the Yaw, Pitch & Roll values.
Project tutorial by Aritro Mukherjee
How to measuring the air quality of the Open Data Institute using an Arduino and a Shinyei PPD-42.
Project tutorial by OpenSensors.io
Take readings from the DHT11 Temperature/Humidity sensor and see them from the Arduino IDE Serial Monitor.
Project tutorial by Zachary Haslam
Use three HC-SR04 ultrasound sensors and two battery displays to show you how close the obstacles are and from which side.
Project tutorial by SurtrTech
Soil moisture sensor which gives you LCD display of percentage of moisture.
Project tutorial by Patel Darshil
This project will show how to set up a 16 x 2 LCD screen and display multiple sensor values.
by Wimpie van den Berg
Make a Ultrasonic Range Detector Using Arduino and SR-04F to measure any distance without using rulers with this simple tutorial.
by Team RZtronics
Use an Arduino, two small servo motors with light sensing photo resistors to steer a solar panel towards the sun. UPDATED
Project tutorial by scott mangiacotti
Simple project to measure temperature (with two sensors) and humidity, and send them to the terminal (monitor) and also to a LCD display.
Project in progress by brunogomezgil
A basic introduction to the low cost and accurate HC-SR04!
Or connect with your social account:
New here? Create an account