The device is capable of testing: PNP, NPN transistors, N or P channel MOSFET, diodes, double diodes, resistors, capacitors...
Project tutorial by Mirko Pavleski
The design and assembly of a DNA transilluminator allowing to examine the results of gel-electrophoresis procedures.
Project tutorial by Gabriel St-Pierre
Using an ATtiny1614 microcontroller with LiPo battery, including USB charging circuitry and logic. It is programmable with Arduino IDE!
Project tutorial by marcozonca
You'll learn how to create an automation system to communicate 3 Arduinos via RS485.
Project tutorial by Moreira
This is a simple square-wave generator that basically uses the TimerOne library allow you to generate a PWM signal at pin 9.
Relay VS Transistor.
Project tutorial by mdraber
Use Arduino, an OLED display and an AD9833 DDS module to create a useful wave generator for your lab.
Project tutorial by janux
Discharge a fully charged Lithium-Ion cell through a resistor while measuring the current flowing through the resistor to calculate capacity
Program an AVR-IoT WG board externally instead of the onboard debugger. I had to workaround as I bricked my nEDBG debugger on my AVR-IoT WG.
A very simple but useful device for your lab.
This project is performing a faster frequency transform (FFT).
Project tutorial by abhilash_patel
Drop-in replacement for Arduino's serial monitor with variable watches.
by Mladen Ilic
This device serves for accurate measurement of small resistances in the range of 0.1 ohm up to 50 ohms.
In this tutorial I am looking at using millis function in the code. Describing the advantages it has over using delay function.
I was looking for ways to teach students the basics of PLC and found the OpenPLC project. Opensource, free and uses the IEC 61131 standard.
"how to hook NRF24 Modules with an Arduino Correctly without killing the module"
Project tutorial by Arnov Sharma
Another simple to build useful instrument in you lab.
Simple to build and useful instrument for your lab.
Rotary Encoder USB Control with single and double click action.
Project in progress by freermottram
A small little console that allows you to quickly set, test, try many different actuators (e.g. servos, stepper, ultrasonic, DHT22, etc... )
Project in progress by willmendil
Inexpensive, precision, autorange capacitance meter with a large range.
A guide how to control 7 segment display with Shift register as well as daisy chain them to create multi digit displays
SNODE – is an open source library that allows to make it easy to build a multi-master serial bus network for hot-plugging nodes with sensors
Project showcase by Oleksandr Kornuta
Purpose of this project is to write a code to control coin acceptor with Arduino so it can be used in other projects
Or connect with your social account:
New here? Create an account