Cute little DIY project using 8x8 LED matrix module and nRF24L01.

Learn how to make a simple line follower robot by using Arduino and very basic electronic components. It is a fully autonomous robot.

Let's make a fully autonomous robot using Arduino and IR sensors. It can explore the surface of a table without falling!

In this tutorial, I'll show you how to use a wireless PlayStation 2 (PS2) controller and an Arduino Uno pilot a robotic tank.

Simple and faster solution for start control your model train via mobile app. Updated in April 2019 to 9 speeds and 122Hz PWM!

A robot which is controlled by an HC-05 module and receives commands using a Bluetooth terminal app.

Make a simple and programmable servo arm out of readily available materials!

Let's start with the basics! 2wd obstacle avoiding robot using arduino uno.

I have a little paint booth in my shop, so I created a device to shake paint cans for me.

An interactive robot that anyone can make! Otto is very easy to 3D print and assemble, walks, dances, makes sounds and avoids obstacles.

With this simple Arduino project, you can servo motor using a remote control.

How to use a Servo.

A panel to control the pitch of a wing (or aircraft or control surface deflection) in a small wind tunnel.

This tutorial will show you how to control servo motor using Arduino Nano and an easy to use Servo motor driver.

Control laser pointer like a gun using a joystick

With this project, you can remotely control your car with Bluetooth.

Design of an Indicative Featured and Speed Controlled Obstacle Avoiding Robot.

PV panel simulation for tracking solar movement.

Allows 4 modes: manual, recording of coordinates, play, and autoplay mode. Uses internal LED diode attached to pin 13 to indicate mode.

In this tutorial we’ll show you how to build a simple and cheap robotic arm from wood scraps and plastic bottles!

This the Bluetooth controlled car that used HC-05 Bluetooth module to communicate with mobile.

A self-controlled robot with specific dimensions and features. It is also designed in hostile shapes which qualify it to fight.

Its super simple, low cost (2 sensor based) line follower robot. If you are a absolute beginner, you can make it only in 2 hours.

A versatile & easy to use vehicle platform for hobby-grade projects: You focus on application logic and the library takes care of the rest.