Make a simple and programmable servo arm out of readily available materials!

This is a project I built from an item I found on Instructables author nipon4666 that I tweaked to correct an issue with high speed motors

This is my first Arduino-based, Bluetooth-controlled RC car. It is controlled by a smart phone application.

You will learn how to make a servo move with an ir remote control and the degree measurement you will see on the lcd display!

A quick tutorial on how the use the L298N Motor Controller with DC motors

A robotic arm made from easily available materials that can record and replay positions.

An Arduino controlled car that avoids obstacles (ie. walls or objects in front of it).

Open hardware/software test bench for solar tracker with virtual instrumentation.

A robot that moves based on the hand gestures

This post shows how to control stepper motor speed and direction of rotation using Arduino UNO board and PS2 joystick.

Disassemble an old printer (in this case a dot matrix) and drive the stepper motor(s) for linear motion or rotation. With Arduino.

In this tutorial, you will learn how to drive DC, stepper and servo motors using an Arduino L293D motor driver shield.

Build your own line following robot (line follower) step by step easily by following this tutorial

[Old - updating soon] - In this project, you can learn how to control servo motor using serial monitor.

In this tutorial we’ll show you how to build a simple and cheap robotic arm from wood scraps and plastic bottles!

Hello world! I made a 1 servo control app yesterday and I said that I would make a multi control, so here is the multi control app!

Design of an indicative featured and speed controlled obstacle avoiding robot.

Let's start with the basics! 2wd obstacle avoiding robot using arduino uno.

In this article we discuss about how to Servo motor interface with Arduino Uno

Give the axis of an inkjet printer a new job.

line following robot setup using an L298N motor driver with an Arduino and two proximity sensor modules.

This is a general purpose 3D-printed linear servo actuator (pusher style). Hope these save you some time on a future project!

This project makes use of the preciseness of a laser beam, just one IR sensor and that good old arduino board to measure the RPM of motors.

This project will show you how to make a laser turret.