In this tutorial I am going to show you how to build a Wireless Weather Station with a big 3.2" Color TFT display using Arduino.

This device measures fine dust and NO2 concentration in the air while on the move and adds GPS coordinates to each measurement location.

A super smart buoy with lots of sensors that sends data over radio to a base station where it is displayed on a real-time dashboard!

In This Tutorial, I will Show You How to Make an Arduino Based MPPT Charge Controller

Follow this project to make an infrared thermometer by yourself!

My project helps visually challenged people to walk without crashing into walls and obstacles. This help them to live freely

This circuit measure the water level of a tank and wirelessly send it to a receiver where it is displayed using a LCD display and LEDs.

Arduino Stepper Motor Barometer with additional displays for last 3 & 6 hour pressure changes.

eNVIRO is an advanced weather station with remote sensor.

Ultra low-cost flow-through photometer for on-line measurements of bacterial density.

Professional quality wireless weather station.

This is a low cost, modular smart board with wireless capabilities.

Kayaking GPS: speed, time, latitude, longitude, distance and azimuth to waypoints, odometer, tide clock, battery monitoring.

Geiger counter measuring radioactivity using Arduino Nano in 3D-printed housing, with OLED display and Li-ion battery.

Use Arduino and Raspberry Pi to get notified if a hot water heater pilot light goes out.

It can measure fine dust, humidity, temperature and CO2 concentration in the air and check it on the internet in real time.

He project is based on LDR sensor, I made the rotatable Solar system which has the home position during night time but when the light is ava

A tech high-school student-teacher team from Uruguay developing High Altitude Balloons for science! IN ACTIVE DEVELOPMENT!

If the temperature measured by DS18B20 is above the predefined threshold, it turns the fan on automatically unless the piezodisk is pressed.

PID control on Arduino with LabView to stabilize a ball on a beam.

How to Make a Non-Touch Doorbell, Body Temperature Detection, GY-906, 433MHz using Arduino