This device measures fine dust and NO2 concentration in the air while on the move and adds GPS coordinates to each measurement location.
Project showcase by Telina
In this tutorial I am going to show you how to build a Wireless Weather Station with a big 3.2" Color TFT display using Arduino.
Project tutorial by Nick Koumaris
In This Tutorial, I will Show You How to Make an Arduino Based MPPT Charge Controller
Project tutorial by ElectronicsLovers
A super smart buoy with lots of sensors that sends data over radio to a base station where it is displayed on a real-time dashboard!
Project tutorial by T3ch Flicks
Follow this project to make an infrared thermometer by yourself!
Project tutorial by Deion Adel
Arduino Stepper Motor Barometer with additional displays for last 3 & 6 hour pressure changes.
Project tutorial by Brett Oliver
This circuit measure the water level of a tank and wirelessly send it to a receiver where it is displayed using a LCD display and LEDs.
Project showcase by Manusha_Ramanayake
Ultra low-cost flow-through photometer for on-line measurements of bacterial density.
by Alex Kutschera
Use Arduino and Raspberry Pi to get notified if a hot water heater pilot light goes out.
Project tutorial by Ryan Carlson
Geiger counter measuring radioactivity using Arduino Nano in 3D-printed housing, with OLED display and Li-ion battery.
Project tutorial by Pedro52
This is a low cost, modular smart board with wireless capabilities.
Project tutorial by Adellar Irankunda
Professional quality wireless weather station.
Kayaking GPS: speed, time, latitude, longitude, distance and azimuth to waypoints, odometer, tide clock, battery monitoring.
Project in progress by Chrisroy
eNVIRO is an advanced weather station with remote sensor.
Project in progress by antiElectron
It can measure fine dust, humidity, temperature and CO2 concentration in the air and check it on the internet in real time.
Project tutorial by 4 developers
PID control on Arduino with LabView to stabilize a ball on a beam.
Project tutorial by Karem BenChikha
How to Make a Non-Touch Doorbell, Body Temperature Detection, GY-906, 433MHz using Arduino
Project tutorial by DKARDU
If the temperature measured by DS18B20 is above the predefined threshold, it turns the fan on automatically unless the piezodisk is pressed.
Project tutorial by Kutluhan Aktar
A tech high-school student-teacher team from Uruguay developing High Altitude Balloons for science! IN ACTIVE DEVELOPMENT!
Project in progress by Club AeroEspacial de la Escuela Tecnica de Melo
Or connect with your social account:
New here? Create an account