Interfacing MAX30102 with Arduino + BPM measure project with OLED + buzzer.

How to measure heart rate with an Arduino.

The smart tunnel prevents further outspread of COVID-19 / SARS-CoV-2. It can disinfect a person fully in a time span of just 15 seconds.

Shows you how you can connect ProtoCentral's MAX30100 breakout board to an Arduino for PulseOx and heart rate measurement and visualization.

This project displays the heart rate at the unit of beats per minute over the Internet so that it can be monitored from anywhere.

Get your heart rate, not just an IR sensor reading.

UV-C / heat, Arduino-controlled, face-mask disinfecting device for Coronavirus (SARS-CoV-2). #COVID19DetectProtect

Displays your pulse rate, blood oxygen level and a moving graph of each heart beat, the photoplethysmogram (PPG).

A heart rate monitoring system that tracks your heart beat in "BMP" but I made a little difference by adding some LabView Visualisations.

How to make an oximeter sensor to measure heartbeat and oxygen saturation in blood, using a few components that any maker already has.

Using AI to detect dangerous bacteria and harmful particles in the water.

I have used a heartbeat sensor module which senses the heartbeat upon putting a finger on the sensor.

Hook up your Arduino to take a look at your ECG, respiration and heart rate using TI's amazing ADS1292R chip.

Android app-controlled, Arduino-based kit that provides simultaneous data about body t°, heart rate, room humidity and t° data.

A photoresistor can sense the subtle changes in light intensity caused by your blood to detect your heartbeat!

Getting some information from human body by using simple sensors and Arduino.

Make an Internet Radio with the mdp music player.

In this project we show how we made a single-lead ECG monitor for heart-rate variability using the MAX30003 and an Arduino Uno.

If you want a device that could measure your heart beat and plot its curve trace on an OLED display, then this will be your best guide.

A wearable device that can conduct ECG on the go and show it on mobile and is available at cheap cost.

An assistive technology for individuals affected by nervous system disorders like Parkinson's and Alzheimer's.

This device detects the presence of your hand and automatically release a specific amount of Hand-wash / Sanitizer to your hand.

Add Arduino and a Force Resistor Sensor to your next healthcare simulation project to detect the amount of pressure applied on a site!

I created an electrocardiogram using TouchDesigner. The image moves according to the value of the sensor connected Arduino.