The design and assembly of a DNA transilluminator allowing to examine the results of gel-electrophoresis procedures.
Project tutorial by Gabriel St-Pierre
Using an ATtiny1614 microcontroller with LiPo battery, including USB charging circuitry and logic. It is programmable with Arduino IDE!
Project tutorial by marcozonca
You'll learn how to create an automation system to communicate 3 Arduinos via RS485.
Project tutorial by Moreira
This is a simple square-wave generator that basically uses the TimerOne library allow you to generate a PWM signal at pin 9.
Project tutorial by Mirko Pavleski
Relay VS Transistor.
Project tutorial by mdraber
Use Arduino, an OLED display and an AD9833 DDS module to create a useful wave generator for your lab.
Project tutorial by janux
Discharge a fully charged Lithium-Ion cell through a resistor while measuring the current flowing through the resistor to calculate capacity
A very simple but useful device for your lab.
This project is performing a faster frequency transform (FFT).
Project tutorial by abhilash_patel
This device serves for accurate measurement of small resistances in the range of 0.1 ohm up to 50 ohms.
In this tutorial I am looking at using millis function in the code. Describing the advantages it has over using delay function.
"how to hook NRF24 Modules with an Arduino Correctly without killing the module"
Project tutorial by Arnov Sharma
Another simple to build useful instrument in you lab.
Simple to build and useful instrument for your lab.
Inexpensive, precision, autorange capacitance meter with a large range.
A guide how to control 7 segment display with Shift register as well as daisy chain them to create multi digit displays
Purpose of this project is to write a code to control coin acceptor with Arduino so it can be used in other projects
This code performs FFT with good accuracy.
If any of the projects you create are designed for portability or remote monitoring use, it usually requires the use of solar panels.
Project tutorial by Iasonas Christoulakis
Program 6 ATtiny85/13A at the same time with this custom programmer board.
The device is sufficiently accurate and uses minimum number of external components.
We will use our M.P.U. 6050 to control a Graphic unit or say Model Paper Plane, which is commonly known as Teapot, with our M.P.U. 6050!
Project tutorial by Mission Critical
A cheap $10 UPDI programmer for Mircochip's new avrTiny processors.
Project tutorial by John Bradnam
Android app to control Arduino's inputs outputs
Project tutorial by moty
Or connect with your social account:
New here? Create an account