A simple way to control a motor with a potentiometer and an Arduino.

How to use a Servo.

A quick tutorial on how the use the L298N Motor Controller with DC motors

There are a lot of tutorials, on how to control Servos with joysticks, or analog sensors, but sometimes we need to control them with buttons

This Arduino Linear Actuator Tutorial shows how to do basic manual control of a large linear actuator using an Arduino and two buttons.

A versatile & easy to use vehicle platform for hobby-grade projects: You focus on application logic and the library takes care of the rest.

Teaches you how to use the Stepper motor and driver in the Arduino Grove Starter Kit.

In this tutorial, you will learn how to drive DC, stepper and servo motors using an Arduino L293D motor driver shield.

Your powerful friend, the transistor can control high-voltage motors and lights from a microcontroller pin.

Able to point in a specific direction or turn by degrees, this motor is a staple in home automation and robotics.

Here's an introduction to control a Nema 17 stepper motor with the help of the Adafruit TB6612 OR A4988 Stepstick OR PHPoC PES-2405 R2

The force resistive sensor outputs the applied force to the Arduino, and we move the servo according to the amount of force.

In this article we discuss about how to Servo motor interface with Arduino Uno

Build a line follower using an LM324N with a backup Arduino Nano.

Disassemble an old printer (in this case a dot matrix) and drive the stepper motor(s) for linear motion or rotation. With Arduino.

Detect obstacles through ultrasonic sensors and then avoid them.

The older members among you can still remember DVD-ROM drives well: let's take another look at the inner values of a past technology.

In this article, you will learn how to control DC, Stepper, and servo motors by Arduino and L293D.

Connect Stepper Motor to Arduino and control it with Rotary Encoder - Quick and Easy!

This project, a smartphone-controlled Arduino 4WD robot car or Bluetooth Arduino robot.

Hello all, I hope you are doing good and safe. I'm here with another very cool project which you can build using some scrap/ used parts.

Give the axis of an inkjet printer a new job.

Interface board capable of communicating an Arduino board or any microcontroller to the Dynamixel motors.

What you need to control the motors of your robot? H-Bridge is the magic word!