We are going to talk about how to Make Internet or Wi-Fi Controller Car Using Esp8266. this can be easily controlled by your smartphone.

This project will show you how to create a Hovercraft.

An interactive robot that anyone can make! Otto is very easy to 3D print and assemble, walks, dances, makes sounds and avoids obstacles.

Here is a step by step guide to making a "crawler robot."

In this tutorial we’ll show you how to build a simple and cheap robotic arm from wood scraps and plastic bottles!

This is a beginner's guide to making your first Arduino robot. Smart phone controlled, wall follower and obstacle avoiding robot.

In this tutorial, I'll show you how to use a wireless PlayStation 2 (PS2) controller and an Arduino Uno pilot a robotic tank.

Design of an indicative featured and speed controlled obstacle avoiding robot.

Open hardware/software test bench for solar tracker with virtual instrumentation.

This is a project I built from an item I found on Instructables author nipon4666 that I tweaked to correct an issue with high speed motors

Its super simple, low cost (2 sensor based) line follower robot. If you are a absolute beginner, you can make it only in 2 hours.

A robotic arm made from easily available materials that can record and replay positions.

A basic robot using Arduino.

Two ways to control the camera cradle, you can put a flashlight, laser, ToF modules...

In this project, you can learn how to control servo motor using serial monitor.

A super simple stair climbing robot.

You want to make a machine that could hold a pen and draw you a picture! than this is the best tutorial to guide you making it.

Create a robot car, which will be controlled from a smartphone using the G-Sensor. Use the RemoteXY service to create GUI and source code!

Hello world! I made a 1 servo control app yesterday and I said that I would make a multi control, so here is the multi control app!

A walking insect looking thing made from leftovers.

Easy to use code to measure PWM signals (<2.5Khz) plus a dedicated function to calibrate the input from an RC receiver, including fail-safe.

It's a BLDC motor based jet turbine.

Objective of the Swarm-bots project is to study controlling the bot so assemble themselves, avoid obstacle and synchronization between bots.

In this project we will connect a Wii nunchuk to an Arduino and control pan/tilt servos.